When our LED bulbs are fused we will throw out the bulb without any checking or anything else. We can repair this LED within eight or five rupees only. This description is little about solved the problems of LED bulb. Initially take a complaint LED for repairing. Before repairing we want to open the Bulb by using an empty spray bottle and by using the bottle a little bit of hit will apply to the LED bulb for separating the outer shell of the Bulb.
High transmittance cover LED bulb will separate when hitting carefully. Then screw out the imported LED chip screw. You should care to screw it out because the chip becomes break when uncarefully screw out. Then dis attach the soldered place of the LED chip carefully. After screw out the LED chip, we can see the Thermal conduction plate and also you should take it out carefully by using a screwdriver.
The cover of the LED bulb name is a High transmittance cover and chip named Imported LED chip and the bottom side of LED named high heat conductive PBT housing and the bottom holder position called optional lamb phases. We should break the soldering point of optional lamb phases and take the board out carefully. Next, we break the capacitor and you should change the capacitor. The capacitor is just priced at only 10 rupees or below.
Kepp changes the capacitor with suitable soldering by connecting the positive-negative phase. After all solder the bottom holder position correctly. Next, we should place the thermally conducting plate at the same position. After all solder the negative and positive phase suitably. Then you can check the bulb connecting to power. Now we can see the bulb becomes solved. This tip is more helpful to all.
The datiled information of this tips gives in the following videos
